INFN wiki - strutture:lnf:da:plasmonx:lpa:spectrometer

The July 2009 BTF test beam

Anonymous (anonymous@undisclosed.example.com) — 2009-10-02T08:56:03+00:00

The July 2009 BTF test beam A two weeks test beam was performed at the BTF.

Anonymous (anonymous@undisclosed.example.com) — 2011-06-22T15:01:26+00:00

Requirements: * resolution <1% up to at least 1GeV. * total length <800 mm * limited encumbrance of the coil on the side of the fibers To this aim both the magnetic field and the magnetic length are increased. A tentative map is shown [mappa finale] and it can be achieved with the requirements described in

Anonymous (anonymous@undisclosed.example.com) — 2012-07-10T14:50:01+00:00

Manuale Spettrometro Specifiche fibre scintillanti: Specifiche PMT: Specifiche MAROC: Articolo su elettronica: ISEG HV Manual

Our Pubblications

Anonymous (anonymous@undisclosed.example.com) — 2012-07-11T13:29:30+00:00

Our Pubblications Development of a multi-GeV spectrometer for laser-plasma experiment at FLAME. Multi-GeV Electron Spectrometer. Related papers A review about laser-driven plasma-based electron accelerators can be found at: Some interesting papers are the following: A- Best results in LPA. In experiments at LBNL the energy gain was extended to the GeV rang…

Slides at meetings and conferences

Anonymous (anonymous@undisclosed.example.com) — 2009-10-02T11:26:54+00:00

Slides at meetings and conferences [SIF2009 (Nadia)] Overview on Sep 2009

Software Documentation

Anonymous (anonymous@undisclosed.example.com) — 2012-10-05T16:09:04+00:00

Software Documentation Data Acquisition and analysis software All directories are referred to the svn repository svn:c1p8.roma1.infn.it/PlasmonX === Beam Tracing (Mathematica notebook) === Directory: SPMFastSimu code for the initial : ???.nb === Detailed Simulation (GEANT) === === Event Reconstruction and analysis === == Unfolding Method based on Bayes' Theorem == Once the electrons are detected using scintillating fibers as detector we need to reconstruct the energy spectrum start…

The Feb 2010 SPARC Test Beam

Anonymous (anonymous@undisclosed.example.com) — 2010-05-24T14:45:19+00:00

The Feb 2010 SPARC Test Beam In order to test the V0 prototype response a test with SPARC electron beam is planned for February 2010. The beam will propagate in vacuum until an Al flange (0.4mm thickness): after that the propagation is in Air, first it goes through a Toroidal Charge Monitoring TCM (distant ~6cm from the Al flange) and then it reaches the scintillating fibers (distant ~12cm from the Al flange).

Anonymous (anonymous@undisclosed.example.com) — 2012-10-05T14:41:11+00:00

Lo Spettrometro Magnetico dell’esperimento PlasmonX -- Tesi di Laurea di S. Martellotti The electron spectrometer of the PlasmonX experiment: from the design to the operation -- PhD Thesis of N. Drenska

Anonymous (anonymous@undisclosed.example.com) — 2010-07-14T08:47:52+00:00

Slide di Paolo Valente sullo studio del Timing in camera pulita. Il trigger ha un anticipo di 600ns rispetto il segnale di risposta del PMT. Per questo motivo e' stato ritardato con la dual timer ed e' stato eseguito uno scan timing via software.

The V0 Prototype

Anonymous (anonymous@undisclosed.example.com) — 2009-10-02T08:52:06+00:00

The V0 Prototype

Anonymous (anonymous@undisclosed.example.com) — 2011-04-26T11:11:58+00:00

Anonymous (anonymous@undisclosed.example.com) — 2013-02-11T11:59:29+00:00

[Commissioning of v1 in Nov 2010] Commissioning of v1 in Jul 2012 Commissioning of v1 in Oct 2012 Intercalibration of v1 in Feb 2013

Design of the V1 Spectrometer

Anonymous (anonymous@undisclosed.example.com) — 2011-06-24T10:22:15+00:00

Design of the V1 Spectrometer Several aspects need to be considered when designing the spectrometer: where and how to impact the magnetic field, where to locate the position detectors, which solution to use for the detectors and how to implement the readout electronics. Each point is detailed here